Agilent Technologies E1300B, E1301B DIAGnosticINTerruptSETupn?, DIAGINTSETUP2 on, DIAGINTSETUP4?

DIAGnostic:INTerrupt:SETup[n]?

• ON or 1 specify that interrupt handling is to be set up for the specified interrupt line. OFF or 0 indicate that interrupt handling of the specified line is to be done by the operating system.

• Related Commands: DIAG:INT:ACT, DIAG:INT:PRIority[n], DIAG:INT:RESP?

• *RST Condition: DIAG:INT:SETup[n] OFF (for all lines)

Example Setup and wait for VXI interrupt response on line 2.

DIAG:INT:PRI2 5	set priority to 5 on line 2
DIAG:INT:SETUP2 ON	handle interrupt on line 2
.	code which will
.	initiate an action
.	resulting in an interrupt
DIAG:INT:RESP?	Read the acknowledge response

:INTerrupt:SETup[n]?	DIAGnostic:INTerrupt:SETup[n]? Returns the current state set by
	DIAG:INT:SETUP[n] < mode> , for the VXI interrupt line specified by [n] in
	… SETup[n]?.
Comments	•	… SETup1? through … SETup7? specify the VXI interrupt lines 1
		through 7.
	• Sending SETup? without an [n] value specifies VXI interrupt line 1.
	• If 1 is returned, interrupt handling is set up for the specified interrupt
		line using the System Instrument (DIAGnostic:INTerrupt commands). If
		0 is returned, interrupt handling is done by the operating system.
	•	Related Commands: DIAG:INT:SETup[n], DIAG:INT:PRIority[n],
		DIAG:INT:ACT, DIAG:INT:RESP?
Example Determine interrupt setup for line 4.
		DIAG:INT:SETUP4?
		enter statement	statement returns 0 or 1

7-20 System Instrument Command Reference