Agilent Technologies 75000 SERIES B DIAGnosticBOOTCOLD, Related Commands Diagbootwarm, Example

DIAGnostic:BOOT:COLD

:BOOT:COLD DIAGnostic:BOOT:COLD causes the System Instrument to restart (re-boot). Configurations stored in non-volatile memory and RS-232 configurations are reset to their default states:

• DRAM, NRAM, and RDISk memory segments are cleared
• Serial Interface parameters set to:
–	BAUD 9600
–	BITS 8
–	PARity NONE
–	SBITs 1
–	DTR ON
–	RTS ON
–	PACE XON

	•	Serial 0 Owner = system
NOTE
	Resetting the serial interface parameters takes about 0.01 seconds for the
	built-in serial port and 0.75 seconds per serial plug-in card. While this is taking
	place the System Instrument will still respond to serial polls. If you are using a
	serial poll to determine when the cold boot cycle is complete, you should insert a
	delay of 1 second per plug-in serial card (E1324) before polling the system
	instrument. This will prevent incorrectly determining that the system instrument
	has completed its boot cycle.
Comments	• The System Instrument goes through its power-up self tests.
	•	Related Commands: DIAG:BOOT:WARM
Example	Re-booting the System Instrument (cold)
		DIAG:BOOT:COLD	force boot

7-6 System Instrument Command Reference