Agilent Technologies E1300B, E1301B SYSTemCOMMunicateSERialnRECeiveSBITs? MIN MAX returns

:COMMunicate :SERial[n] [:RECeive] :SBITs?

Example

SYSTem :COMMunicate :SERial[n] [:RECeive] :SBITs?

SYSTem:COMMunicate:SERial[n][:RECeive]:SBITs? [MIN MAX] returns:

•The current stop bit setting if no parameter is sent.

•The maximum allowable setting if MAX is sent.

•The minimum allowable setting if MIN is sent.

Querying the current stop bit configuration.
SYST:COMM:SER0:SBITs?	:REC is implied
enter statement	statement enters 1 or 2

:COMMunicate :SERial[n] :TRANsmit :AUTO

Parameters

SYSTem:COMMunicate:SERial[n]:TRANsmit:AUTO < auto_cntrl> when ON, sets the transmit pacing mode to be the same as that set for receive pacing. When OFF, the transmit pacing mode may be set independently of the receive pacing mode.

Parameter	Parameter	Range of	Default
Name	Type	Values	Units
auto_cntrl	boolean	0 1 OFF ON	none

Comments	•	For an Agilent E1324A, AUTO is always ON. Trying to set OFF or 0 will
		generate an error.
	•	DIAG:BOOT:COLD will set … AUTO to ON.
	•	Related Commands: SYST:COMM:SER[n]:REC:PACE:PROT,
		SYST:COMM:SER[n]:TRAN:PACE:PROT
	•	*RST Condition: … TRAN:AUTO ON
Example Link transmit pacing with receive pacing
		SYST:COMM:SER0:TRAN:AUTO ON
:COMMunicate SYSTem:COMMunicate:SERial[n]:TRANsmit:AUTO? returns the current
:SERial[n] :TRANsmit	state of receive to transmit pacing linkage.
:AUTO?
Comments	•	For an Agilent E1324A, AUTO is always ON. In this case … AUTO? will
		always return a 1.
Example Is AUTO ON or OFF?
		SYST:COMM:SER0:TRAN:AUTO?
		enter statement	statement enters the number 1
			or 0

System Instrument Command Reference 7-47