AI2524 Router Card User’s Manual

transferred successfully. A series of V characters indicates that a checksum verification of the image is occurring after the image is writ- ten to Flash memory.

Note:

If you enter n after the Erase flash before

 

writing? prompt, the copy process continues. If you

 

enter y and confirm the erasure, the erase routine begins.

 

Be sure you have enough Flash memory space before

 

entering n at the erasure prompt.

This example demonstrates the process of copying a system image named gs7-k into the current Flash configuration when a file named gs7-k already exists:

env-chassis# copy tftp flash

IP address or name of remote host [131.108.13.111]? Name of file to copy? gs7-k

File gs7-k already exists; it will be invalidated!

Copy gs7-k from 131.108.13.111 into flash memory? [confirm] 2287500 bytes available for writing without erasure.

Erase flash before writing? [confirm]n Loading from 131.108.1.111:!!!!...

[OK - 1906676/2287500 bytes] Verifying via checksum...

vvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvv vvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvvv vvvvvvvvvvvvvvvvvvvvvvvvvvvvvv

Flash verification successful. Length = 1902192, checksum = 0x12AD

The exclamation point (!) indicates that the copy process is taking place. Each exclamation point (!) indicates that 10packets have been transferred successfully. A series of V characters indicates that a checksum verification of the image is occurring after the image is writ- ten to Flash memory.

In this example, the Flash security jumper is not installed, so you can- not write files to Flash memory. Also, be sure to set the write-protect switch on the Flash memory card to unprotected.

Router# copy tftp flash

Flash: embedded flash security jumper(12V) must be strapped to modify flash memory

Note:

To terminate this copy process, press <Ctrl-^> (th

 

<Ctrl>, <Shift>, and <6> keys on a standard keyboard)

 

simultaneously. Although the process terminates, the

 

partial file copied before the termination remains until th

 

entire Flash memory is erased.

 

 

Page 7-6

August 1997

 

2524UM

Page 106
Image 106
AIS AI2524 user manual If you enter n after the Erase flash before, Writing? prompt, the copy process continues. If you