AIS AI2524 user manual Using AutoInstall

AI2524 Router Card User’s Manual

6. To see the configuration in NVRAM, enter th show startup- config command at the enable prompt:

Router# show startup-config

The results of the show running-config and show star- tup-config commands will be different if you have mad changes to the configuration but have not yet written them to

NVRAM.

7.To make your changes permanent, enter the copy running- config startup-config command at the enable prompt:

Router# copy running-config startup-config

*******

The router is now configured and will boot with the configuration you entered.

Using AutoInstall

The AutoInstall process is designed to configure the router automati- cally after connection to your WAN. For AutoInstall to work properly, a Transmission Control Protocol Internet Protocol (TCP/IP) host on your network must be reconfigured to provide the required configura- tion files. The TCP/IP host may exist anywhere on the network as long as these conditions are maintained:

1.The host must be on the remote side of the router's synchronous serial connection to the WAN.

2.User Datagram Protocol (UDP) broadcasts to and from the router and the TCP/IP host must be enabled.

This functionality is coordinated by your system administrator at th site where the TCP/IP host is located. You should not attempt to us AutoInstall unless the required files have been provided on the TCP/ IP host.

AutoInstall works on synchronous serial connections only.

Take these steps to prepare your router for the AutoInstall process:

3. Attach the WAN cable to the router.

Page 16-4	August 1997
	2524UM