AIS AI2524 user manual X25 facility cug group-number, X25 facility packetsize in-sizeout-sizeor

AI2524 Router Card User’s Manual

Configure X.25 User Facilities

The X.25 software provides commands to support X.25 user facilities (options specified by the creators of the X.25 Recommendation) that allow you to implement features such as accounting, user identifica- tion, and flow control negotiation. You can choose to configure facil- ities on a per-map basis or on a per-interface basis. In the following list, the x25 map commands configure facilities on a per-map basis; the x25 facility commands specify the values sent for all encap- sulation calls originated by the interface. Routed calls are not affected by the facilities specified for the outgoing interface.

To set the supported X.25 user facilities, perform one or more of these tasks in interface configuration mode:

zSelect the closed user group.

x25 facility cug group-number

or

x25 map protocol address [protocol2 address2 [...[protocol9 address9 ]]] x121- address cug number

zSet flow control parameter negotiation values to request on outgo- ing calls.

x25 facility packetsize in-sizeout-sizeor

x25 map protocol address [protocol2 address2 [...[protocol9 address9 ]]] x121- address packetsize in-size out-size

x25 facility windowsize in-sizeout-sizeor

x25 map protocol address [protocol2 address2 [...[protocol9 address9 ]]] x121- address windowsize in-size outsize

zSet reverse charging.

x25 facility reverse or

x25 map protocol address [protocol2 address2 [...[protocol9 address9 ]]] x121- address reverse

Page 12-26	August 1997
	2524UM