AIS AI2524 user manual Set the network type to DDS

AI2524 Router Card User’s Manual

Configuring DDS The 4-wire 56/64-kbps DSU/CSU WAN module is configured for DDS (which are leased or dedicated lines) as the factory default, but it can be configured for either switched 56/64-kbps service or DDS. Th DDS configuration is described in this section. To configure the 4-wire 56/64-kbps DSU/CSU WAN module for circuit-switched service, follow the instructions in the previous section Configuring Switched 56.

Take these steps to configure the 4-wire 56/64-kbps DSU/CSU mod- ule for DDS, substituting the correct addresses and host names as ap- propriate for your network

1. Enter enable mode:

Router> enable password: enablepassword

2. Enter configuration mode:

Router# config term

Router(config)#

3. Assign an IP address to the serial port on the module:

Router(config)# interface serial port _number

Router(config-if)# ip address ipaddress subnet mask

Router(config-if)# no keepalive

4. Set the network type to DDS:

Router(config-if)# service-module 56k network-type ads

5. Return to user EXEC mode:

Router(config-if)# exit

Router(config)# exit

Router# exit

Router>

Page 16-16	August 1997
	2524UM