Chapter 5: Using AutoInstall
August 1997 Page 5-27
2524UM
Use this configuration? [yes/no]: yes
Building configuration...
Use the enabled mode 'configure' command to modify this confi gura tion.
Router#
Use the Streamlined Setup Facility
The streamlined setup command facility is available only if you
router is running from ROM monitor and has RXBOOT ROMs in-
stalled. The streamlined setup command facilit y permits your router to
load a system image from a network server when there are problems
with the startup configuration. The Cisco IOS software automatically
puts you in the streamlined setup command facility when your router
is accidentally or intent io nall y rebo oted (or you are attempting to load
a system image from a network server) after:
zYou issued an erase startup-config command, thereby
deleting the startup configuration file.
zYou have bit 6 (ignore NVRAM configuration) set in the config-
uration register.
zYour startup configuration has been c o rr upted.
zYou configured the router to boot from a network server (the last
four bits of the configuration register are not equal to 0 or 1) and
there is no Flash or no valid image in Flash.
zYou configured the rout er to boot the R XBOOT image.
The streamlined setup command facility differs fro m the standard
setup command facility because the streamlined facility does not ask
you to configure global router parameter s. You are prompted only to
configure interface parameters, which permit your router to boot.
This example shows a router entering the streamlined setup command
facility:
— System Configuration Dialog —
Default settings are in square bracket s ' []'.
Configuring interface IP parameters for netbooting: