AIS AI2524 Cisco IOS software supports no more than one PPP, Half-bridge per Ethernet subnetwork

AI2524 Router Card User’s Manual

Figure11-1: Router Serial Interface Configured as a Half-

Bridge

Note:	The Cisco IOS software supports no more than one PPP
	half-bridge per Ethernet subnetwork.

Beginning in global configuration mode, configure a serial interface to function as a half-bridge:

1.Specify the interface and enter interface configuration mode. interface serial number

2.Enable PPP half-bridging for one or more routed protocols: ppp bridge ip

ppp bridge ipx [novell-ether arpa sap snap]

3.Provide a protocol address on the same subnetwork as the remote network.

ip address n.n.n.n ipx network network

Note:	You must enter the ppp bridge command either when
	the interface is shut down or before you provide a protocol
	address for the interface.

Page 11-18	August 1997
	2524UM