AMX NXT-1200V manual System Settings Page Elements Cont, Firmware Pages and Descriptions

Firmware Pages and Descriptions

System Settings Page Elements (Cont.)

Wireless Settings (Cont.):
Gateway	Sets a gateway value to the panel.
	• Gateway is a computer that either performs protocol conversion between
	different types of networks/applications or acts as a go-between two or more
	networks that use the same protocols.
Host Name
	Sets the host name of the panel.
Primary DNS
	Sets the address of the primary DNS server used for host name lookups.
	• DNS (Domain Name System) is software that lets users locate computers on
	a local network or the Internet (TCP/IP network) by host and domain. The
	DNS server maintains a database of host names for its’ domain and their
	corresponding IP Addresses.
Secondary DNS
	Sets a secondary DNS value to the panel.
Domain
	Sets the unique name on the Internet to the panel for DNS look-up.
	• The panel belongs to the DNS domain.
Ethernet Mode
	Sets the speed of the Ethernet connection to the panel.
	• Choices are: Auto, 10 Half Duplex, 10 Full Duplex, 100 Half Duplex, or
	100 Full Duplex.
MAC Address
	Displays a read-only field that is factory set by AMX for the built-in Ethernet
	interface.
Master Connection:	Sets the NetLinx Master communication values:
Type
	Sets the NetLinx Master to communicate with the panel via either USB or
	Ethernet. This is based on the cable connection from the rear.
	ICSNet is not a supported option on this panel.
	• Ethernet is a CAT-5 cable (10/100Base T terminated in an RJ-45 connector)
	used to network computers together and is used in most LAN (local area
	networks). This description is also used to refer to both wired and wireless
	communication.
	• USB option cannot be used on Modero panels which are not equipped with a
	rear USB port.
Mode
	Cycles between the different connection modes (URL, Listen, and Auto)
	(ETHERNET Only - disabled when USB is selected)
	• URL - In this mode, enter the IP/URL, Master Port Number, and
	username/password (if used) on the Master.
	- The System Number field is read-only because the panel obtains this
	information from the communicating Master.
	• Listen - In this mode, add the Modero panel address into the URL List in
	NetLinx Studio and set the connection mode to Listen. This mode allows the
	Modero touch panel to "listen" for the Master’s communication signals.
	- The System Number and Master IP/URL fields are red-only.
	• Auto - In this mode, enter the System Number and a username/password
	(if applicable). This mode is used when both the panel and the NetLinx
	Master are on the same Subnet and the Master has its UDP feature enabled.
	- Master IP/URL field is read-only.
System Number
	Allows you to enter a system number. Default value is 0 (zero).
	(ETHERNET Only - disabled when USB is selected)
Master IP/URL
	Sets the Master IP or URL of the NetLinx Master.
	(ETHERNET Only - disabled when USB is selected)
Master Port Number
	Allows you to enter the port number used with the NetLinx Master.
	• Default value is 1319. (ETHERNET Only - disabled when USB is selected)
Username/Password
	If the target Master has been previously secured, enter the alpha-numeric string
	(into each field) assigned to a pre-configured user profile on the Master.
	This profile should have the pre-defined level of access/configuration rights.

1200V Modero Video Touch Panels 119