AMX NXT-1200V manual Installing the NXD into a Flat Surface using #4 screws, Front Bezel

Installation Procedures: NXD-1200V Panels

The drywall clip set must be re-ordered from AMX if the drywall clip is bent accidentally during an installation or removed during a re-installation.

11.Place the magnetic faceplate (A in FIG. 39) back onto the main NXD unit (B in FIG. 39). Make sure to align the Microphone, Light, and PIR Motion sensor locations to their respective openings on the front bezel/faceplate.

12.Reconnect the terminal RJ-45, Ethernet, USB, and any optional audio/video wiring to their respective locations on either the NXA-AVB/ETHERNET Breakout Box, Ethernet port, or NetLinx Master.

13.Reconnect the terminal power connector on the 12 VDC-compliant power supply and apply power.

Installing the NXD into a Flat Surface using #4 screws

Mounting screws (#4, not included) are secured through circular holes located at the left and right sides of the NXD panel. The most important thing to remember when mounting the NXD is that the

outer frame (Mounting Tabs) must be installed flush against the mounting surface.

It is recommended that you cutout the surface slightly smaller than what is outlined in the installation drawings so that you can make any necessary cutout adjustments.

1.Prepare the area by removing any screws or nails from the surface before beginning the cutout process.

2.Cut out the surface for the 12-inch Wall Mount using the dimensions shown in FIG. 40.

THESE 4 HOLES ARE ONLY REQUIRED

WHEN MOUNTING UNIT TO A SOLID

SURFACE (PODIUM, DESK, ETC.).

SECURE UNIT WITH #4 SCREWS.

CUTOUT

FRONT BEZEL

FIG. 40 NXD-1200V Wall Mount panel dimensions using #4 mounting screws

3.Remove the magnetic faceplate/bezel (A in FIG. 41) from the main NXD unit (B in FIG. 41) by gripping the faceplate and pulling with gentle outward force.

42 1200V Modero Video Touch Panels