AMX NXT-1200V manual Button Assignments, Front Panel Components, Rear Panel Components

Introduction

1200V Panel Specifications (Cont.)

Button Assignments:	Button assignments can only be adjusted in TPD4 and not on the panels.
	• Button channel range: 1 - 4000 button push and Feedback (per address
	port)
	• Button variable text range: 1 - 4000 (per address port)
	• Button states range: 1 - 256 (General Button; 1 = Off State, 2 = On State)
	• Level range: 1 - 600 (default level value 0-255, can be set up to 1-65535)
	• Address port range: 1 - 100
Front Panel Components:
Light sensor:	• Photosensitive light detector for automatic adjustment of the panel
	brightness (a dim room results in a dimmer LCD display and a bright
	room results in a brighter LCD display).
	Note: The light sensor can be adjusted via the Sensor Setup Page section
	on page 110.
Motion sensor (PIR):	• Proximity Infrared Detector to wake the panel when the panel is
	approached.
	• Activation range: + 20° vertically from center and + 45° horizontally
	from center.
	Note: The motion sensor can be adjusted via the Sensor Setup page
	(Sensor Setup Page section on page 110).
Front setup access button:	• Provides both access to the Setup and Calibration pages and toggles the
	panel between a "sleep" and "wake" state.
	- When wired, "sleep" status means the backlight is Off.
	- When battery operated, wireless "sleep" status means the touch panel
	base is either Off or "suspended".
Microphone:	• Used for intercom applications
	(requires an NXA-AVB/ETHERNET Breakout Box for analog
	communication).
Speakers:	• Stereo output with a frequency response of 450 Hz - 7 KHz
Rear Panel Components:	(Side panel location on NXD-Wall Mount panels)
Audio/Video connector:	• RJ-45 connector for communication of differential audio/video signals
	to/from the touch panel (panel type dependant). This connector receives
	Composite video, Stereo (left/right) audio, and microphone audio.
	• Video is received via the NXA-AVB/ETHERNET Breakout Box.
	Configuring video windows for playback is done using TPDesign4.
	• In-bound audio (from the breakout box) gets directed to the speakers.
	• Out-bound audio is sent from the on-board microphone (on the
	front-panel). Selecting audio files for playback is configured through
	TPDesign4.
Ethernet 10/100 port:	• RJ-45 port for 10/100 Mbps communication. The Ethernet port
	automatically negotiates the connection speed (10 Mbps or 100 Mbps),
	and whether to use half duplex or full duplex mode.
	• These panels communicate with the NetLinx® Master using the ICSP
	protocol over Ethernet.
Ethernet 10/100 LEDs:	• LEDs show communication activity and connection information:
	A-activity - Yellow LED lights when receiving or transmitting Ethernet
	data packets.
	L-link - Green LED lights when the Ethernet cables are connected and
	terminated correctly.
PWR connector:	• 2-pin 3.5 mm mini-Phoenix connector.

1200V Modero Video Touch Panels 3