AMX NXT-1200V manual Notches are

	Installation Procedures: NXD-1200V Panels
		4 notches are
		required if the
Install the four drywall		unit is installed in
		drywall using the
clip sets (included)
		four (4) provided
into these holes
		drywall expansion
		clips

Mounting Tab

A - Faceplate

B - Main NXD unit consists of the touch panel and housing

(bezel)

FIG. 39 Wall Mount panel (NXD) installation configuration for drywall surfaces

4.Thread the incoming RJ-45, Ethernet, USB, and any other audio/video wiring (from their terminal locations) through the cutout opening. Refer to the Wiring Guidelines for the 1200V Panels section on page 45 for pinout descriptions.

Leave enough slack in the wiring to accommodate any re-positioning of the panel.

5.Connect all data and power wiring connectors to their corresponding locations along the side of the (un-powered) NXD touch panel.

Verify the terminal end of the power cable is not connected to a power supply before plugging in the 2-pin power connector.

The USB connectors can be from a either a USB extension cable, or a wireless USB RF transmitter.

6.Test the incoming wiring by attaching the panel connections to their terminal locations and applying power. Verify the panel is receiving power and functioning properly to prevent repetition of the installation.

7.Disconnect the terminal end of the power cable from the connected power supply.

Don’t disconnect the connectors from the touch panel. The unit must be installed with the attached connectors before being inserted into the drywall.

8.Insert the four sets of drywall screws and expansion clips into the four oval notch locations along the top/bottom edges of the main unit (FIG. 39).

9.Carefully insert the main unit (with expansion clips) into the cutout until the Mounting Tabs on the NXD unit lie flush against the wall (FIG. 39).

10.Tighten the drywall clip sets (screws and clips) until the Mounting Tabs are securely fastened and flush against the wall.

1200V Modero Video Touch Panels 41