AMX NXT-1200V manual knockouts, screws into the places

Installation Procedures: NXD-1200V Panels

	Stud
	Cable	C - Optional CB-TP
	knockouts	conduit/wallbox
Mounting Tab
Install the four #4-40		Installed flush
screws into the places
		against the
indicated	SURFACE
		finished wall
		surface

Do not use these

tabs to mount the conduit /wallbox These are ONLY used to

secure the main unit to the CB

B - Main NXD unit consists of

A - Faceplatethe touch panel and backbox housing (bezel)

FIG. 37 Wall Mount panel installation configuration for pre-existing conduit/wallbox in a pre-wall construction

Don’t disconnect the connectors from the touch panel. The unit must be installed with the attached connectors before being inserted into the conduit box.

6.Carefully slide the main unit (B in FIG. 37) into the conduit box, so the Mounting Tabs lie flush against the conduit box (C in FIG. 37).

7.Insert and secure the four securing #4-40 Mounting Screws into their corresponding holes located along the sides of the NXD (FIG. 36 and FIG. 37).

8.Place the magnetic faceplate (A in FIG. 37) back onto the main NXD unit (B in FIG. 37). Make sure to align the Microphone, Light, and PIR Motion sensor locations to their respective openings on the front bezel/faceplate.

9.Reconnect the terminal RJ-45, Ethernet, USB, and any optional audio/video wiring to their respective locations (outside the conduit box) on either the NXA-AVB/ETHERNET Breakout Box, Ethernet port, or NetLinx Master.

10.Reconnect the terminal power connector on the 12 VDC-compliant power supply and apply power.

1200V Modero Video Touch Panels 39