AMX NXT-1200V manual screws not included, Install the four #4

	Installation Procedures: NXD-1200V	Panels
Attachment is done	Flat surface
along the edges of	(can include a
the cutout	wall, podium, or
Install the four (#4)	other flat
mounting screws	surface)
into the holes

(screws not included)

A - Faceplate	B - Main NXD unit consists of
(bezel)	the touch panel and housing

FIG. 41 Wall Mount panel installation configuration for flat/solid surfaces

4.Thread the incoming RJ-45, Ethernet, USB, and any other audio/video wiring (from their terminal locations) through the cutout opening. Refer to the Wiring Guidelines for the 1200V Panels section on page 45 for pinout descriptions.

Leave enough slack in the wiring to accommodate any re-positioning of the panel.

5.Connect all data and power wiring to their corresponding locations along the side of the (un-powered) NXD touch panel.

Verify the terminal end of the power cable is not connected to power supply before plugging in the 2-pin power connector.

The USB connectors can be from a either a USB extension cable, or a wireless USB RF transmitter.

6.Test the incoming wiring by connecting the panel connections to their terminal locations and applying power. Verify the panel is receiving power and functioning properly before finalizing the installation.

7.Disconnect the terminal end of the power cable from the power supply.

Don’t disconnect the connectors from the touch panel. The unit must be installed with the necessary connectors before being inserted into the solid surface.

8.Carefully slide the main unit into the cutout until the Mounting Tabs of the NXD unit lie flush against the wall.

9.Insert and secure the four #4 screws into their corresponding holes located along the sides of the NXD (using a grounded Phillips-head screwdriver) until the unit is secure and flush against the wall.

1200V Modero Video Touch Panels 43