AMX NXT-1200V manual 8020MM 5264MM 5590MM 6166MM

Installation Procedures: NXD-1200V Panels

Verify the Strain Relief Grommet is securely closed over the cables and the clip is facing the correct direction (upwards). The process of securing the strain relief grommet may require the use of pliers. Also verify the length and location of the inserted cables. Once the strain relief grommet is closed, it is difficult to re-open.

5.Firmly push the Strain Relief Grommet into the opening (toward the inside) until the rim is securely flush against the back of the rear plastic cover (FIG. 33).

6.Securely grasp both sides of the NXD panel (with LCD, MB-TP12 back box, and attached cables), rotate the entire unit over, and lie it on a flat level surface.

7.Note the available mounting contact surface area on the rear plastic cover of the MB-TP12 (FIG. 34). This area represents the space available for use with a VESA connector plate.

.80[20MM]

2.52[64MM]

3.55[90MM]

2.61[66MM]

FIG. 34 MB-TP12 Mounting contact surface area

8.Insert and secure the twelve #6-32 securing screws into their pre-drilled holes along the edges of the NXD unit (FIG. 33). This step secures the NXD unit to the rim of the rear plastic cover.

9.Align a VESA mount connector (purchased separately) to the four #8-32 screw holes on the back of the rear plastic cover (FIG. 33).

10.Insert the four provided #8-32 screws through the VESA mount’s four holes and then into the pre-drilled holes on the rear plastic cover.

When installing a VESA mount to the rear plastic cover, use only the AMX provided #8-32 screws.

11.Secure these four #8-32 screws to the rear plastic cover by using a grounded Phillips-head screwdriver. This step secures the VESA mount to the rear of the panel.

Refer to your particular VESA mount manufacturer’s installation procedures for further surface mounting procedures.

36 1200V Modero Video Touch Panels