AMX NXT-1200V manual Installing the NXA-BASE/B to an NXT Modero Panel

Touch Panel Accessories

Installing the NXA-BASE/B to an NXT Modero Panel

The battery base must be installed onto the NXT panel without any NXT-BP batteries.

1.Power Off the panel before attempting to use the NXA-BASE/B.

2.Place the empty battery base onto a flat/level surface.

3.Verify the alignment of the Panel Interface connectors between the panel (male connector) and base (female connector) (FIG. 27).

Battery Compartment	Captive fasteners
pulls outwards	(secure base to
	panel)

Panel Interface connector (female)

Alignment pegs

FIG. 27 NXA-BASE/B showing Panel Interface and connector locations

4.Carefully place the Modero panel over the base alignment pegs (FIG. 27 and FIG. 28).

The battery base cannot be "hot-swapped". A panel receiving power through a connected 12 VDC-compliant power supply cannot have a battery base installed onto the bottom of the panel while powered. POWER OFF the panel before installing the NXA-BASE/B.

"Hot swapping" could damage the base and cause it not to be recognized by the panel.

5.Gently apply downward pressure until the panel is securely mounted to the battery base (FIG. 28).

6.Firmly grip both the panel (from the side) and battery base (from below) together.

7.Gently place the touch panel LCD facedown onto a soft cloth (this prevents scratching of the LCD while the battery base is being secured).

8.Locate the captive fasteners on the underside of the battery base by angling the base combo slightly forwards.

9.Secure each captive fastener head using a grounded flat-head screwdriver until the NXA-BASE/B is securely attached to the underside of the NXT Modero touch panel.

10.Firmly grip the panel LCD/base combo and gently rotate the unit back onto the base.

1200V Modero Video Touch Panels 27