AMX NXT-1200V manual Audio/Video Port Connections and Wiring, Wiring a power connection

Installation Procedures: NXD-1200V Panels

Wiring a power connection

To use the 2-pin 3.5 mm mini-Phoenix connector with a 12 VDC-compliant power supply, the incoming PWR and GND wires from the external source must be connected to their corresponding locations on the connector (FIG. 43).

PWR +

GND -

To the Touch Panel

FIG. 43 NetLinx power connector wiring diagram

Power Supply

1.Insert the PWR and GND wires on the terminal end of the 2-pin 3.5 mm mini-Phoenix cable.

Match the wiring locations of the +/- on both the power supply and the terminal connector.

2.Tighten the clamp to secure the two wires. Do not tighten the screws excessively; doing so may strip the threads and damage the connector.

3.Verify the connection of the 2-pin 3.5 mm mini-Phoenix to the power supply.

Audio/Video Port: Connections and Wiring

The following table shows the signal and pinout/pairing information used on the RJ-45 Audio and Video connections.

Audio/Video RJ-45 Pinout Information

Pin	Wire Color	Function	Polarity
1	Orange/White	Right Audio In	+
2	Orange	Right Audio In	-
3	Green/White	Video In	-
4	Blue	Mic Out	-
5	White/Blue	Mic Out	+
6	Green	Video In	+
7	White/Brown	Left Audio In	+
				TIA 568B
8	Brown	Left Audio In	-

(female)

1 2 3 4 5 6 7 8

1 2 3 4 5 6 7 8

(male)

RJ-45 connector - pin configurations

Refer to the Installing CAT5 Suppression Ferrites section on page 14 for detailed information on how to install the necessary number of CAT5 Suppression Ferrites on the Black A/V RJ-45 cable connected to the panel.

46 1200V Modero Video Touch Panels