Channel Use

02444 - 2472 MHz

12406 - 2435 MHz

22444 - 2472 MHz

32406 - 2435 MHz

42444 - 2472 MHz

52406 - 2435 MHz

62444 - 2472 MHz

72406 - 2435 MHz

8Not used

9Radio device deactivated

Note:

If two yellow washer remote systems are on the

 

same set, it is recommended to set one system to

 

an even channel and the other to an odd channel.

 

Only odd numbered channels are legally

 

permitted for use in France

To change the radio channel:

•With the camera off, set the channel and then turn the camera on. Or,

•Move the channel selection switch to 9 (deactivated) and then turn it to the required channel within half a second. Or,

•Set the channel selection switch on the camera to the new channel – the RF LED goes red. Then turn the camera off and back on again after approximately 5 seconds.

The RDY LED of the radio system Aphoto indicates the status of the radio as follows:

LED Color

Status

Off

Wireless deactivated (channel 9 selected)

 

or camera deactivated

 

or camera has no power

 

 

Alternating

Radio modem is being initialised.

red/green

Do not activate the WMU yet.

 

 

Green blinking

Radio modem is ready, activate the WMU

 

 

Green

Wireless remote control OK

 

 

Red

Channel selection switch has been changed.

 

Wireless remote control will continue to function but the

 

channel will be changed the next time it is switched on.

 

-> Reset to the previously selected channel if the change

 

was unintentional, or turn module off and on again

 

to change channel.

 

 

Red blinking

Hardware error in radio module.

 

If this error persists after restarting the camera,

 

send the camera for service.

 

 

Red blinking rapidly

Radio fault: another ARRI wireless system

 

is on the same channel nearby. Select another channel.

ARRIFLEX 416 Plus

187