Installation

upper screw

rosette lower screw clamp

LWS-5

front screw clamp

416 Lightweight Support LWS-5

The 416 Lightweight Support LWS-5 is a sturdy, three point bracket for mounting 15 mm lightweight support rods. The LWS-5 is fitted with an Accessory Rosette to replace the camera‘s rosette which is covered when the LWS-5 is fitted Aphoto.

•Fit the LWS-5 to the camera by first engaging the two guide pins of the upper 3/8-16 screw on the camera right side Aphoto. This will position the LWS-5 so that the 3/8-16 screw on the front of the bracket lines up with the threaded hole In the camera. Engage this screw by a few threads but leave it loose Aphoto.

•Tighten the two screws on the camera right side – the lower one is accessed through a hole in the Accessory Rosette teeth Aphoto.

•Tighten the front screw.

•Slide the support rods into the guides and clamp.

Note:

Due to the camera‘s small dimensions and because

 

the distance from the lens to the support rods is

 

fixed, the rod clamps of the LWS-5 project below

 

the camera base. To mount the camera with the

 

LWS-5 fitted on a support system such as the Steadi-

 

cam, it is necessary to fit the 416 Riser. This

 

presents a flat base, clear of the support rods,

 

with selection of threaded holes.

26