Magazines

film core slit

lay-on roller arm

film core

lower magazine

throat

Timecode sensitivity switch

•Hold the film between thumb and middle finger of your left hand, while using your index finger to push the film head into the lower magazine throat slot. The angle at which the film enters is not as critical as it is on the old SR magazines.

•Keep pushing the film in with your index finger until you see the sprockets rotate Aphoto. Now take hold of the film core again and rotate it counter-clockwise. This will pull the film from the throat into the take-up chamber.

•Thread the film around the rear guide roller following the path indicated in the magazine.

•Insert the film head into the film core and manually wind the core holder two or three turns until the film winds tightly onto the core.

•Unlatch the lay-on roller arm.

•Close and lock the take-up side door.

•If using timecode, set the sensitivity switch according to the table In the Timecode section of this manual. The switch is located at the top left corner of the feed side door Aphoto.

38