Note: | The automatic image compensation locks in two |
| positions 180° apart. This allows the image |
| compensation to be set to provide an upright |
| image when using a finder extension. |
If the viewfinder image is inverted without the finder extension, the image compensation must be adjusted to the opposite locking position.
Inverting the Image
•Press the locking button Aphoto and keep pressed.
•Turn the adjustment knob Aphoto.
•Release the locking button Aphoto.
•Keep turning the adjustment knob Aphoto until the locking button pops up and the adjustment knob locks in position.
Removing the Viewfinder System
Before removing the viewfinder system, the viewfinder arm should be brought back to its normal position.
•Loosen the three fastening screws Aphoto.
•Pull the viewfinder system up and off the camera body.
•If the camera is to be used without the viewfinder, fit the cover to protect the beamsplitter prism.
locking button adjustment knob
screws
Attaching the Viewfinder System
•Position the viewfinder system on the camera body from above.
•Tighten the fastening screws.
Viewfinder Warnings
A LED glows when the camera is not running at the set speed (ASY). This LED blinks when the battery voltage is low (BAT).
Optics
53