Camera Operation

PHASE button RUN button

Shifting phase

After the camera has run up, the frame rate can be temporarily increased by 0.2 fps while the button the “PHASE” is held pressed Aphoto. This is normally used when synchronizing to an interlaced video signal – look through the viewfinder and hold the “PHASE“ button pressed until the bar in the video picture is no longer visible on the monitor. Always confirm results with a film test.

Displaying Power Supply Voltage (Mode 3)

•Change from Mode 1 to Mode 3 by pressing the “MODE” button twice. The power supply voltage is shown in the lower line of the display.

Note:

If the camera has an OBB-2 attached, the

 

options of battery capacity (in percent) or

 

remaining magazines can be displayed instead

 

of voltage.

64