Switching the Beeper On and Off (Mode 6)
Standby Operation
•Press the “MODE“ button until the display shows Mode 6.
•By pressing the “SEL” button once, activate the display for setting the Beeper.
•Within three seconds, press the “SET” button to select one of the four settings.
•Pressing the “MODE” button confirms the selection.
Setting the Volume of the Warning Signal (Mode 6)
•Press the “MODE“ button until the display shows Mode 6.
•Press the “SEL” button two times to activate the display for setting the Beeper volume.
•Select the desired volume with the “SET” button. 0…off
3…maximum volume
Display | Beep on start | Beep on stop | Operation |
| |||
|
|
|
|
LS _ _ | off | off |
|
LS – _ | on | off |
|
LS _ – | off | on |
|
LS – – | on | on |
|
|
|
| Camera |
69