Camera Operation
Overview of Display Modes
Mode 1 is displayed:
after switching on the camera, after pressing the “RUN” button
or 30 seconds after the last operation.
| 1st Display Line | 2nd Display Line | Adjustment Possibility |
Mode 1 | total exposed film counter (m/ft) or | frame rate (fps) or | |
| take counter (m/ft) | ESU in standby and | selection of a standard frame rate |
|
| frame rate (fps) while running |
|
|
| (external control connected) |
|
Mode 2 | programmed frame rate (PS) | programmed frame rate (fps) | programmed frame rate |
| ESU – external control connected |
|
|
Mode 3 | total exposed film counter (m/ft) or | power supply voltage (V), or (with | unit of measurement (m/ft) |
| configuration of the film counter | ||
|
| or remaining magazines | press SET to set battery warning level |
Mode 4 | timecode hours:minutes | timecode seconds:frame rate | press and hold SET for 3 seconds to turn TC on/off |
| press SEL to show TC error codes | press SEL to show TCS settings | press and hold SEL and then |
|
| and activity of clock adjustment | press and hold SET for 3 seconds to reset clock |
|
|
| adjustment to default |
Mode 5 | timecode user bits (1st 4 digits) | timecode user bits (2nd 4 digits) | setting of user bits |
Mode 6 | sequence and volume of the acoustic | brightness of the keypad | beep at start, stop, neither or both |
| warning signal |
| beeper volume |
|
|
| keypad backlight brightness |
Mode 7 | GLo – RGB ARRIGLOW | ARRIGLOW color | preset colors |
|
| r, G & B values | r, G & B values |
|
|
|
|
58