a.At the login prompt, type craft and press Return . (If the login prompt is not displayed, press Return once or twice.)
NOTE:
To send the information to the DEFINITY LAN Gateway system, the Return key (located on the right side of your keyboard) must be pressed after you type a command or a response to a prompt. On some keyboards, this key is labeled Enter instead of Return . If your keyboard has both a
Return key and an Enter key (as on the 513 and 615 keyboards), use the Return key.
The system responds with the Password prompt.
b.Enter the default password for the craft login.
The system responds with the prompt: Enter terminal type
c.Enter one of the following:
513 for a 513 BCT or 715 BCT; enter 513 also for a 610/615 BCT or a PC with a 513 emulation package. (Since 513 is the default, just press Return to select it.)
4410 for a 4410 or 5410 terminal; enter 4410 also for a 610/615 BCT or a PC with a 4410 emulation package.
4425 for a 4425 or 5425 terminal
5420 for a 5420 or 4415 terminal
vt220 (or other terminal listed in Appendix B)
If the terminal and modems (if applicable) are connected properly and the options are set correctly, the system responds with the DEFINITY LAN Gateway main menu.
4.Place the labels supplied with the DEFINITY LAN Gateway system hardware as follows:
a.Place the label containing the DEFINITY LAN Gateway system shutdown warning next to the cabinet Power switch.
b.Place the tape maintenance log label near the system assembly.
5.Give the program (original) tape to the DEFINITY LAN Gateway system administrator. The blank tape that came with the system will be installed in the drive later in this chapter when the system is backed up.
Proceed to the next section, ‘‘Initial Administration.’’
