
LCD messages
Below is a list of messages that are displayed on the LCD when a problem occurs. Check the cause of the error and take corrective actions according to the list.
Message | Cause | Action | Details |
BLACK INK | The machine is asking whether | If you replaced the black ink tank, | page 97 |
CHANGED? | you replaced the black ink tank. press [ ]. If you did not, press [ | ]. |
BLACK INK LOW The ink level in the black ink tank is low.
Make sure you have a new black ink page 97 tank ready to replace the used one
when ink runs out. If the machine stops printing when copying or photo printing, you can continue printing by pressing [OK/Set]. However, note that ink may run out. If print quality deteriorates or the printout is blank, replace the ink tank.
CANNOT USE THIS | You have inserted a memory | Remove the memory card from the | page 49 |
CARD | card incompatible with the | card slot, then turn the power OFF |
|
TURN OFF AND ON | machine or a damaged memory | and ON again. |
|
| card into the card slot. |
|
|
|
|
|
|
CARD READER | You tried to start photo printing | Wait until the card slot is no longer | — |
BUSY | when the card slot was in use | being used by the computer. |
|
| by the computer. |
|
|
CARTRIDGE | The print head holder cannot |
JAMMED | move. This is normally due to a |
| paper jam. |
Clear the paper jam or whatever is page 114 obstructing the print head holder
and then press [OK/Set]. Do not attempt to move the print head holder manually.
Chapter 11 | Troubleshooting | 135 |