Cisco Systems ASA5515K9, ASA 5500 Diverting Traffic to the ASA IPS module

58-17
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter58 Configuring the ASA IPS Module
Configuring the ASA IPS module
Examples
The following example assigns sensor1 and sensor2 to context A, and sensor1 and sensor3 to context B.
Both contexts map the sensor names to “ips1” and “ips2.” In context A, sensor1 is set as the default
sensor, but in context B, no default is set so the default that is configured on the ASA IPS module is used.
hostname(config-ctx)# context A
hostname(config-ctx)# allocate-interface gigabitethernet0/0.100 int1
hostname(config-ctx)# allocate-interface gigabitethernet0/0.102 int2
hostname(config-ctx)# allocate-interface gigabitethernet0/0.110-gigabitethernet0/0.115
int3-int8
hostname(config-ctx)# allocate-ips sensor1 ips1 default
hostname(config-ctx)# allocate-ips sensor2 ips2
hostname(config-ctx)# config-url ftp://user1:passw0rd@10.1.1.1/configlets/test.cfg
hostname(config-ctx)# member gold
hostname(config-ctx)# context sample
hostname(config-ctx)# allocate-interface gigabitethernet0/1.200 int1
hostname(config-ctx)# allocate-interface gigabitethernet0/1.212 int2
hostname(config-ctx)# allocate-interface gigabitethernet0/1.230-gigabitethernet0/1.235
int3-int8
hostname(config-ctx)# allocate-ips sensor1 ips1
hostname(config-ctx)# allocate-ips sensor3 ips2
hostname(config-ctx)# config-url ftp://user1:passw0rd@10.1.1.1/configlets/sample.cfg
hostname(config-ctx)# member silver
hostname(config-ctx)# changeto context A
...
What to Do Next
Change to each context to configure the IPS security policy as described in “Diverting Traffic to the ASA
IPS module” section on page58-17.
Diverting Traffic to the ASA IPS module
This section identifies traffic to divert from the ASA to the ASA IPS module.
Prerequisites
In multiple context mode, perform these steps in each context execution space. To change to a context,
enter the changeto context context_name command.