Cisco Systems ASA5515K9, ASA 5500 Creating a Layer 3/4 Class Map for Management Traffic

32-14
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter32 Configuring a Service Policy Using the Modular Polic y Framework
Identifying Traffic (Layer 3/4 Class Maps)
Examples
The following is an example for the class-map command:
hostname(config)# access-list udp permit udp any any
hostname(config)# access-list tcp permit tcp any any
hostname(config)# access-list host_foo permit ip any 10.1.1.1 255.255.255.255
hostname(config)# class-map all_udp
hostname(config-cmap)# description "This class-map matches all UDP traffic"
hostname(config-cmap)# match access-list udp
hostname(config-cmap)# class-map all_tcp
hostname(config-cmap)# description "This class-map matches all TCP traffic"
hostname(config-cmap)# match access-list tcp
hostname(config-cmap)# class-map all_http
hostname(config-cmap)# description "This class-map matches all HTTP traffic"
hostname(config-cmap)# match port tcp eq http
hostname(config-cmap)# class-map to_server
hostname(config-cmap)# description "This class-map matches all traffic to server 10.1.1.1"
hostname(config-cmap)# match access-list host_foo
Creating a Layer 3/4 Class Map for Management Traffic
For management traffic to the ASA, you might want to perform actions specific to this kind of traffic.
You can specify a management class map that can match an access list or TCP or UDP ports. The types
of actions available for a management class map in the policy map are specialized for management
traffic. See the “Supported Features for Management Traffic” section on page32-2.
match precedence value1 [value2] [value3]
[value4]
Example:
hostname(config-cmap)# match precedence 1
4
Matches up to four precedence values, represented by the TOS
byte in the IP header, where value1 through value4 can be 0 to 7,
corresponding to the possible precedences.
match rtp starting_port range
Example:
hostname(config-cmap)# match rtp 4004 100
Matches RTP traffic, where the starting_port specifies an
even-numbered UDP destination port between 2000 and 65534.
The range specifies the number of additional UDP ports to match
above the starting_port, between 0 and 16383.
match tunnel-group name
(Optional)
match flow ip destination-address
Example:
hostname(config-cmap)# match tunnel-group
group1
hostname(config-cmap)# match flow ip
destination-address
Matches VPN tunnel group traffic to which you want to apply
QoS.
You can also specify one other match command to refine the
traffic match. You can specify any of the preceding commands,
except for the match any, match access-list, or match
default-inspection-traffic commands. Or you can also enter the
match flow ip destination-address command to match flows in
the tunnel group going to each IP address.
Command Purpose