Glossary
GL-6
Cisco ASA 5500 Series Configuration Guide using the CLI
Dynamic NAT See NAT and address translation.
Dynamic PAT Dynamic Port Address Translation. Dynamic PAT lets multiple outbound sessions appear to originate
from a single IP address. With PAT enabled, the ASA chooses a unique port number from the PAT IP
address for each outbound translation slot (xlate). This feature is valuable when an ISP cannot allocate
enough unique IP addresses for your outbound connections. The global pool addresses always come
first, before a PAT address is used. See also NAT, Static PAT, and xlate.
E
ECHO See ping, ICMP. See also inspection engine.
EGP Exterior Gateway Protocol. Replaced by BGP. The ASA does not support EGP. See also BGP.
EIGRP Enhanced Interior Gateway Routing Protocol. The ASA does not support EIGRP.
EMBLEM Enterprise Management BaseLine Embedded Manageability. A syslog format designed to be
consistent with the Cisco IOS system log format and is more compatible with CiscoWorks
management applications.
encryption Application of a specific algorithm or cipher to data so as to render the data incomprehensible to those
unauthorized to see the information. See also decryption.
ESMTP Extended SMTP. Extended version of SMTP that includes additional functionality, such as delivery
notification and session delivery. ESMTP is described in RFC 1869, SMTP Service Extensions.
ESP Encapsulating Security Payload. An IPsec protocol, ESP provides authentication and encryption
services for establishing a secure tunnel over an insecure network. For more information, refer to
RFCs 2406 and 1827.
F
failover, failover
mode
Failover lets you configure two ASAs so that one will take over operation if the other one fails. The
ASA supports two failover configurations, Active/Active failover and Active/Standby failover. Each
failover configuration has its own method for determining and performing failover. With
Active/Active failover, both units can pass network traffic. Active/Active failover lets you configure
load balancing on your network. Active/Active failover is only available on units running in multiple
context mode. With Active/Standby failover, only one unit passes traffic while the other unit waits in
a standby state. Active/Standby failover is available on units running in either single or multiple
context mode.
Fixup See inspection engine.
Flash, Flash
memory
A nonvolatile storage device used to store the configuration file when the ASA is powered down.
FQDN/IP Fully qualified domain name/IP address. IPsec parameter that identifies peers that are security
gateways.