43-17
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter43 Configuring Inspection of Basic Internet Protocol s
HTTP Inspection
Configuring an HTTP Inspection Policy Map for Additional Inspection Control
To specify actions when a message violates a parameter, create an HTTP inspection policy map. You can
then apply the inspection policy map when you enable HTTP inspection.
Note When you enable HTTP inspection with an inspection policy map, strict HTTP inspection with the action
reset and log is enabled by default. You can change the actions performed in response to inspection
failure, but you cannot disable strict inspection as long as the inspection policy map remains enabled.
To create an HTTP inspection policy map, perform the following steps:
Step1 (Optional) Add one or more regular expressions for use in traffic matching commands according to the
“Creating a Regular Expression” section on page13-12. See the types of text you can match in the match
commands described in Step3.
Step2 (Optional) Create one or more regular expression class maps to group regular expressions according to
the “Creating a Regular Expression Class Map” section on page 13-15.
Step3 (Optional) Create an HTTP inspection class map by performing the following steps.
A class map groups multiple traffic matches. Traffic must match all of the match commands to match
the class map. You can alternatively identify match commands directly in the policy map. The difference
between creating a class map and defining the traffic match directly in the inspection policy map is that
the class map lets you create more complex match criteria, and you can reuse class maps.
To specify traffic that should not match the class map, use the match not command. For example, if the
match not command specifies the string “example.com,” then any traffic that includes “example.com”
does not match the class map.
For the traffic that you identify in this class map, you can specify actions such as drop, drop-connection,
reset, mask, set the rate limit, and/or log the connection in the inspection policy map.
If you want to perform different actions for each match command, you should identify the traffic directly
in the policy map.
a. Create the class map by entering the following command:
hostname(config)# class-map type inspect http [match-all | match-any] class_map_name
hostname(config-cmap)#
Where class_map_name is the name of the class map. The match-all keyword is the default, and
specifies that traffic must match all criteria to match the class map. The match-any keyword
specifies that the traffic matches the class map if it matches at least one of the criteria. The CLI
enters class-map configuration mode, where you can enter one or more match commands.
b. (Optional) To add a description to the class map, enter the following command:
hostname(config-cmap)# description string
c. (Optional) To match traffic with a content-type field in the HTTP response that does not match the
accept field in the corresponding HTTP request message, enter the following command:
hostname(config-cmap)# match [not] req-resp content-type mismatch
d. (Optional) To match text found in the HTTP request message arguments, enter the following
command:
hostname(config-cmap)# match [not] request args regex [regex_name | class
regex_class_name]