Cisco Systems ASA5515K9, ASA 5500 - page 872

42-8
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter42 Getting Started with Application Layer Protocol Inspectio n
Configuring Application Layer Protocol Inspection
•Instant Messaging—See the “Configuring an Instant Messaging Inspection Policy Map for
Additional Inspection Control” section on page43-21
•IP Options—See the “Configuring an IP Options Inspection Policy Map for Additional Inspection
Control” section on page 43-25
•MGCP—See the “Configuring an MGCP Inspection Policy Map for Additional Inspection Control”
section on page 44-13.
•NetBIOS—See the “Configuring a NetBIOS Inspection Policy Map for Additional Inspection
Control” section on page 43-29
•RADIUS Accounting—See the “Configuring a RADIUS Inspection Policy Map for Additional
Inspection Control” section on page46-10
•RTSP—See the “Configuring an RTSP Inspection Policy Map for Additional Inspection Control”
section on page 44-16
•SIP—See the “Configuring a SIP Inspection Policy Map for Additional Inspection Control” section
on page 44-20
•Skinny—See the “Configuring a Skinny (SCCP) Inspection Policy Map for Additional Inspection
Control” section on page 44-26
•SNMP—See the “Configuring an SNMP Inspection Policy Map for Additional Inspection Control”
section on page 46-11.
Step3 To add or edit a Layer 3/4 policy map that sets the actions to take with the class map traffic, enter the
following command:
hostname(config)# policy-map name
hostname(config-pmap)#
The default policy map is called “global_policy.” This policy map includes the default inspections listed
in the “Default Settings” section on page 42-4. If you want to modify the default policy (for example, to
add or delete an inspection, or to identify an additional class map for your actions), then enter
global_policy as the name.
Step4 To identify the class map from Step1 to which you want to assign an action, enter the following
command:
hostname(config-pmap)# class class_map_name
hostname(config-pmap-c)#
If you are editing the default policy map, it includes the inspection_default class map. You can edit the
actions for this class by entering inspection_default as the name. To add an additional class map to this
policy map, identify a different name. You can combine multiple class maps in the same policy if desired,
so you can create one class map to match certain traffic, and another to match different traffic. However,
if traffic matches a class map that contains an inspection command, and then matches another class map
that also has an inspection command, only the first matching class is used. For example, SNMP matches
the inspection_default class map.To enable SNMP inspection, enable SNMP inspection for the default
class in Step 5. Do not add another class that matches SNMP.
Step5 Enable application inspection by entering the following command:
hostname(config-pmap-c)# inspect protocol
The protocol is one of the following values: