24-2
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter24 Configuring OSPF
Licensing Requirements for OSPF
The ASA can run two processes of OSPF protocol simultaneously on different sets of interfaces. You
might want to run two processes if you have interfaces that use the same IP addresses (NAT allows these
interfaces to coexist, but OSPF does not allow overlapping addresses). Or you might want to run one
process on the inside and another on the outside, and redistribute a subset of routes between the two
processes. Similarly, you might need to segregate private addresses from public addresses.
You can redistribute routes into an OSPF routing process from another OSPF routing process, a RIP
routing process, or from static and connected routes configured on OSPF-enabled interfaces.
The ASA supports the following OSPF features:
•Support of intra-area, interarea, and external (Type I and Type II) routes.
•Support of a virtual link.
•OSPF LSA flooding.
•Authentication to OSPF packets (both password and MD5 authentication).
•Support for configuring the ASA as a designated router or a designated backup router. The ASA also
can be set up as an ABR.
•Support for stub areas and not-so-stubby areas.
•Area boundary router Type 3 LSA filtering.
OSPF supports MD5 and clear text neighbor authentication. Authentication should be used with all
routing protocols when possible because route redistribution between OSPF and other protocols (like
RIP) can potentially be used by attackers to subvert routing information.
If NAT is used, if OSPF is operating on public and private areas, and if address filtering is required, then
you need to run two OSPF processes—one process for the public areas and one for the private areas.
A router that has interfaces in multiple areas is called an Area Border Router (ABR). A router that acts
as a gateway to redistribute traffic between routers using OSPF and routers using other routing protocols
is called an Autonomous System Boundary Router (ASBR).
An ABR uses LSAs to send information about available routes to other OSPF routers. Using ABR Type
3 LSA filtering, you can have separate private and public areas with the ASA acting as an ABR. Type 3
LSAs (interarea routes) can be filtered from one area to other, which allows you to use NAT and OSPF
together without advertising private networks.
Note Only Type 3 LSAs can be filtered. If you configure the ASA as an ASBR in a private network, it will
send Type 5 LSAs describing private networks, which will get flooded to the entire AS, including public
areas.
If NAT is employed but OSPF is only running in public areas, then routes to public networks can be
redistributed inside the private network, either as default or Type 5 AS External LSAs. However, you
need to configure static routes for the private networks protected by the ASA. Also, you should not mix
public and private networks on the same ASA interface.
You can have two OSPF routing processes, one RIP routing process, and one EIGRP routing process
running on the ASA at the same time.
Licensing Requirements for OSPF
The following table shows the licensing requirements for this feature: