81-18
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter81 Managing Software and Configurations
Configuring Auto Update Support
Step5 (Optional) If the Auto Update Server has not been contacted for a certain period of time, entering the
following command causes it to stop passing traffic:
hostname(config)# auto-update timeout period
The period argument specifies the timeout period in minutes between 1 and 35791. The default is to
never time out (zero minutes). To restore the default, enter the no form of this command.
Use the auto-update timeout command to be sure that the ASA has the most recent image and
configuration. This condition is reported with system log message 201008.
In the following example, an ASA is configured to poll an Auto Update Server with the IP address
209.165.200.224, at port number 1742, from the outside interface, with certificate verification.
The ASA is also configured to use the hostname as the device ID and to poll an Auto Update Server every
Friday and Saturday night at a random time between 10:00 p.m. and 11:00 p.m. On a failed polling
attempt, the ASA will try to reconnect to the Auto Update Server ten times, and will wait three minutes
between attempts at reconnecting, as shown in the following example:
hostname(config)# auto-update server
https://jcrichton:farscape@209.165.200.224:1742/management source outside
verify-certificate
hostname (config)# auto-update device-id hostname
hostname (config)# auto-update poll-at Friday Saturday 22:00 randomize 60 2 10
Configuring Client Updates as an Auto Update Server
Entering the client-update command enables updates for ASAs configured as Auto Update clients and
lets you specify the type of software component (ASDM or boot image), the type or family of ASA,
revision numbers to which the update applies, and a URL or IP address from which to obtain the update.
To configure the ASA as an Auto Update Server, perform the following steps:
Step1 To enable client update, enter the following command:
hostname(config)# client-update enable
Step2 Configure the following parameters for the client-update command that you want to apply to the ASAs:
client-update {component {asdm | image} | device-id dev_string |
family family_name | type type} url url-string rev-nums rev-nums}
The component {asdm | image} parameter specifies the software component, either ASDM or the boot
image of the ASA.
The device-id dev_string parameter specifies a unique string that the Auto Update client uses to identify
itself. The maximum length is 63 characters.
The family family_name parameter specifies the family name that the Auto Update client uses to identify
itself. It can be asa, pix, or a text string with a maximum length of seven characters.
The rev-nums rev-nums parameter specifies the software or firmware images for this client. Enter up to
four, in any order, separated by commas.
The type type parameter specifies the type of clients to notify of a client update. Because this command
is also used to update Windows clients, the list of clients includes several Windows operating systems.
The ASAs in the list may include the following:
•asa5505: Cisco 5505 ASA