Cisco Systems ASA5515K9, ASA 5500 Configuration Examples for the ASA CX Module

59-21
Cisco ASA 5500 Series Configuration Guide using the CLI
Chapter59 Configuring the ASA CX Module
Configuration Examples for the ASA CX Module
src ip/id=0.0.0.0, mask=0.0.0.0, port=0
dst ip/id=192.168.0.100, mask=255.255.255.255, port=2000, dscp=0x0
input_ifc=inside, output_ifc=identity
3. In the packet captures, the redirect request should be going to destination port 2000.
Configuration Examples for the ASA CX Module
The following example diverts all HTTP traffic to the ASA CX module, and blocks all HTTP traffic if
the ASA CX module card fails for any reason:
hostname(config)# access-list ASACX permit tcp any any eq port 80
hostname(config)# class-map my-cx-class
hostname(config-cmap)# match access-list ASACX
hostname(config-cmap)# policy-map my-cx-policy
hostname(config-pmap)# class my-cx-class
hostname(config-pmap-c)# cxsc fail-close auth-proxy
hostname(config-pmap-c)# service-policy my-cx-policy global
The following example diverts all IP traffic destined for the 10.1.1.0 network and the 10.2.1.0 network
to the ASA CX module, and allows all traffic through if the ASA CX module fails for any reason.
hostname(config)# access-list my-cx-acl permit ip any 10.1.1.0 255.255.255.0
hostname(config)# access-list my-cx-acl2 permit ip any 10.2.1.0 255.255.255.0
hostname(config)# class-map my-cx-class
hostname(config-cmap)# match access-list my-cx-acl
hostname(config)# class-map my-cx-class2
hostname(config-cmap)# match access-list my-cx-acl2
hostname(config-cmap)# policy-map my-cx-policy
hostname(config-pmap)# class my-cx-class
hostname(config-pmap-c)# cxsc fail-open auth-proxy
hostname(config-pmap)# class my-cx-class2
hostname(config-pmap-c)# cxsc fail-open auth-proxy
hostname(config-pmap-c)# service-policy my-cx-policy interface outside