4-4
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
Chapter4 Error Messages
EID-2003 Error deleting roll. There was an error when CTC tried to delete
the roll.
EID-2004 No IOS slot selected. You did not select a Cisco IOS slot.
EID-2005 CTC cannot find the online help files for {0}. The files may
have been moved, deleted, or not installed. To install online
help, run the setup program on the software or documentation
CDs.
CTC cannot find the online help files for the
specified window. The files might have
been moved, deleted, or not installed. To
install online help, run the setup program on
the software CD.
EID-2006 Error editing circuit(s). {0} {1}. An error occurred when CTC tried to open
the circuit for editing.
EID-2007 Unable to save preferences. CTC cannot save the preferences.
EID-2008 Unable to store circuit preferences: {0} CTC cannot find the file needed to save the
circuit preferences.
EID-2009 Unable to download package:
{0}
Refer to the error message text.
EID-2010 Delete destination failed. CTC could not delete the destination.
EID-2011 Circuit destroy failed. CTC could not destroy the circuit.
EID-2012 Reverse circuit destroy failed. CTC could not reverse the circuit destroy.
EID-2013 Circuit creation error. Circuit creation cannot proceed due to
changes in the network which affected the circuit(s) being
created. The dialog will close. Please try again.
Refer to the error message text.
EID-2014 No circuit(s) selected. {0} You must select a circuit to complete this
function.
EID-2015 Unable to delete circuit {0}as it has one or more rolls. You must delete the rolls in the circuit
before deleting the circuit itself.
EID-2016 Unable to delete circuit. CTC could not delete the tunnel as there are
circuits that use the tunnel.
EID-2017 Error mapping circuit. {0} There was an error mapping the circuit.
EID-2018 Circuit roll failure. The circuit has to be in the DISCOVERED
state in order to perform a roll.
There was a failure in circuit roll. Change
the circuit state to DISCOVERED and
proceed.
EID-2019 Circuit roll failure. Bridge and roll is not supported on a
DWDM circuit .
Refer to the error message text.
EID-2020 Circuit roll failure. The two circuits must have the same
direction.
Refer to the error message text.
EID-2021 Circuit roll failure. The two circuits must have the same size. Refer to the error message text.
EID-2022 Circuit roll failure. A maximum of two circuits can be selected
for a bridge and roll operation.
Refer to the error message text.
EID-2023 Unable to create new user account. Refer to the error message text.
EID-2024 Node selection error. There was an error during node selection.
Table4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description