Cisco Systems ONS 15310-CL, ONS 15310-MA manual Line, External

Chapter 4 Error Messages

Table 4-1	Error Messages (continued)
Error Warning
ID	Error Warning Message	Description
EID-6006	Could not assign timing references:	Refer to the error message text.
	- NE reference can only be used if timing mode is LINE.
	- A BITS reference can only be used if timing mode is not
	LINE.
	- A line reference can only be used if timing mode is not
	EXTERNAL.
EID-6008	SF BER and SD BER are not provisionable on the protect line	Refer to the error message text.
	of a protection group.
WID-6009	If Autoadjust GFP Buffers is disabled, GFP Buffers Available	Refer to the warning message text.
	must be set to an appropriate value based on the distance
	between the circuit end points.
WID-6010	If Auto Detection of credits is disabled, Credits Available must	Refer to the warning message text.
	be set to a value less than or equal to the number of receive
	credits on the connected FC end point.
WID-6011	Idle filtering should be turned off only when required to operate	Refer to the warning message text.
	with non-Cisco Fibre Channel/FICON-over-SONET
	equipment.
EID-6012	Could not change the retiming configuration. There are circuits	You cannot change the timing configuration
	on this port.	on this port unless the circuits on this port
		are deleted.
EID-6013	NTP/SNTP server could not be changed.	Refer to the error message text.
	{1}
EID-6014	Operation failed. The reference state is OOS.	Change the Out-of-service state to Active.
EID-6015	Distance Extension cannot be disabled if the port media type is	Refer to the error message text.
	FICON 1Gbps ISL or FICON 2Gbps ISL.
EID-6016	Card mode cannot be changed to Fibre Channel Line Rate if the	Refer to the error message text.
	port media type is FICON 1Gbps ISL or FICON 2Gbps ISL.
EID-6017	The destination of a {0} route cannot be a node IP address.	A node IP address cannot be the destination
		for a static route.
EID-6018	The destination of a {0} route cannot be the same as the subnet	Refer to the error message text.
	used by the node.
EID-6019	The destination of a static route cannot be 255.255.255.255	The network address such as
		255.255.255.255 is not valid. Enter a valid
		address.
EID-6020	The destination of a static route cannot be the loopback network	Refer to the error message text.
	(127.0.0.0/8)
EID-6021	The subnet mask length for a non-default route must be	Length of subnet mask must be within the
	between 8 and 32.	specified range.
EID-6022	The subnet mask length for a default route must be 0.	Refer to the error message text.
EID-6023	The destination of a {0} route cannot be an internal	The destination of a static route must not be
	network{1}.	an internal network.

Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0

4-36