Chapter 3 Installing the Cisco XR 12410 Router

Connecting Line Card Network Interface Cables

Use the following procedure as an example to route the network interface cables through the cable-management system and connect them to the line card.

Step 1 Route an interface cable across the horizontal cable-management tray, through the cable tray opening to connect it to the line card:

For legacy fiber-optic line cards, go to Step 2.

For current fiber-optic line cards, go to Step 6.

Step 2 Install a plastic bend-radius clip on the strain-relief ferrule on the connector (see blow-out in Figure 3-26).

Note The bag of bend-radius clips (Part Number 800-06119-01) in the accessories box that shipped with your router contains two sizes of bend-radius clips. The clip size is determined by the diameter of the strain-relief ferrule on the cable connectors. Use the size that provides the most secure fit on the strain-relief ferrule on the cable connectors in use at your site.

Step 3 Insert the cable connector into its assigned port.

Step 4 Route the cable up the cable-management bracket and carefully press the cable into the channel so it is held in place by the cable clips (Figure 3-26b).

Step 5 Repeat Steps 3 through 5 for each additional cable connection to that line card.

 

 

Cisco XR 12410 Router Installation Guide

 

 

 

 

 

 

OL-13832-01

 

 

3-35

 

 

 

Page 111
Image 111
Cisco Systems XR 12410 manual OL-13832-01