Chapter 4 Troubleshooting the Installation

Troubleshooting the Processor Subsystem

PRP Ethernet Ports and Status LEDs

The PRP has two 8-pin media-dependent interface (MDI) RJ-45 ports for either IEEE 802.3 10BASE-T (10 Mbps) or IEEE 802.3u 100BASE-TX (100 Mbps) Ethernet connections. These ports are labeled ETH 0 and ETH 1.

The transmission speed of the Ethernet port is not user-configurable. You set the speed through an autosensing scheme on the PRP which is determined by the network that the Ethernet port is connected to. However, even at an autosensed data transmission rate of 100 Mbps, the Ethernet port can only provide a usable bandwidth of substantially less than 100 Mbps. You can expect a maximum usable bandwidth of approximately 20 Mbps when using an Ethernet connection.

The following LEDs on the front panel indicate traffic status and port selection (Figure 4-4):

LINK, EN, TX, RX—Indicate link activity (LINK), port enabled (EN), data transmission (TX), and data reception (RX).

PRIMARY—Indicates which Ethernet port is selected (ETH 0 or ETH 1).

Note Because both ports are supported on the PRP, ETH 0 is always on. ETH 1 lights when it is selected.

Figure 4-4 Port Activity LEDs—Partial Front Panel

ETH 0

-1 SLOT0 - SLOT

PRIMARY

 

RX

EN

TX

 

LINK

 

ETH 1

PRIMARY

 

RX

EN

TX

 

LINK

 

70693

 

 

Cisco XR 12410 Router Installation Guide

 

 

 

 

 

 

OL-13832-01

 

 

4-17

 

 

 

Page 141
Image 141
Cisco Systems XR 12410 manual Port Activity LEDs-Partial Front Panel