Chapter 3 Installing the Cisco XR 12410 Router
Reinstalling Components After Installing the Chassis
Reinstalling the Blower Module
Use the following procedure to reinstall the blower module in the chassis.
Step 1 Install the blower module into the chassis (Figure
a.Lift the blower module (with two hands) and slide it halfway into the module bay.
b.Slowly push the blower module into the chassis until it mates with the backplane connector at the back of the module bay.
Caution To prevent damage to the connectors, do not use excessive force when inserting the blower module into the chassis.
c.Tighten the captive screws on the blower module to secure it to the chassis.
Figure 3-22 Installing the Blower Module
0
A
C
T
TX | TX |
0 | 0 |
RX | RX |
TX | TX |
1 | 1 |
RX |
|
122100
| Cisco XR 12410 Router Installation Guide |
|
