Chapter 3 Installing the Cisco XR 12410 Router
Reinstalling Components After Installing the Chassis
Reinstalling AC PEMs
Use the following procedure to reinstall the AC PEMs back into the chassis.
Step 1 Install the AC PEMs (Figure
a.Slide the power supply into the bay until it mates with its backplane connector.
b.Lift the ejector lever into place and tighten the captive screw to securely seat the power supply to the backplane connector.
Caution To prevent damage to the power shelf backplane connector, do not use excessive force when inserting the power supply into the chassis.
Figure 3-20 Installing an AC PEM
PWR OK
FAULT
TEMP
ILIM
PWR OK
FAULT
TEMP
ILIM
93228
0 
Step 2 Repeat Step 1 for the other power supply.
Step 3 Go to the “Reinstalling the Blower Module” section on page
| Cisco XR 12410 Router Installation Guide |
|
