
Chapter 5 Maintaining the Router
Removing and Replacing the Blower Module
Step 2 Install the new blower module into the chassis (Figure
a.Lift the blower module (with two hands) and slide it halfway into the module bay.
b.Slowly push the blower module into the chassis until it mates with the backplane connector at the back of the module bay.
Caution To prevent damage to the connectors, do not use excessive force when inserting the blower module into the chassis.
c.Tighten the captive screws on the blower module to secure it to the chassis.
•The (green) OK status indicator on the front of the blower module goes on. If the OK indicator does not light, see the “Troubleshooting the Blower Module Installation” section on page
Figure 5-6 Installing the Blower Module
0
A
C
T
TX | TX |
0 | 0 |
RX | RX |
TX | TX |
1 | 1 |
RX |
|
122100
| Cisco XR 12410 Router Installation Guide |
|