Cisco Systems XR 12410 manual Removing and Installing a Chassis

Chapter 5 Maintaining the Router

Removing and Installing a Chassis

Step 2 Remove the card (a CSC in this example):

a.Pivot the ejector levers to unseat the card from the backplane connector.

b.Grasp the card by its metal card carrier and slide the card out of the slot (Figure 5-25).

–Place the card directly into an antistatic bag or other ESD-preventive container.

Figure 5-25 Removing a Card from the Switch Fabric and Alarm Card Cage

Clock scheduler card

ALARM		-3/STM-POS
		S
	2	FC

6DS3–SMB	12DS3–SMB
P/H/F	P/H/F

-48/STM-16-SCPOS OC-12/STM-4 ATM

ST ETERNET E PROCESSOR

53270

Air filter door

Step 3 To install the card, reverse the procedure in Step 2.

Step 4 Close the air filter door and tighten the captive screws.

Removing and Installing a Chassis

This section provides the procedures to remove and replace a chassis. You may need to perform this procedure to replace a defective chassis or move it to another location. These instructions include the steps directing you to removal and replacement instructions for individual components such as power supplies and line cards.

	Cisco XR 12410 Router Installation Guide
5-42	OL-13832-01