8.See the Tru64 UNIX Installation Guide and install the base operating system from the
After the new kernel has booted to
9.Determine the /dev/disk/dskn values to be used for cluster installation (Section 6.6.3).
10.Use the disklabel utility to label the disks used to create the cluster (Section 6.6.4).
11.See the TruCluster Server Software Installation manual and install the TruCluster Server software subsets then run the clu_create utility to create the first cluster member. Do not allow clu_create to boot the system. Shut down the system to the console prompt (Section 6.6.5).
12.Reset the bootdef_dev console environment variable to provide multiple boot paths to the cluster member boot disk (Section 6.6.6). Boot the first cluster member.
13.See the TruCluster Server Software Installation manual and add subsequent cluster member systems (Section 6.6.7). As with the first cluster member, you will have to:
•Use the wwidmgr command to set the device unit number for the member system boot disk.
•Set the bootdef_dev environment variable.
•Reset the bootdef_dev environment variable after building a kernel on the new cluster member system.
Consult the following documentation to assist you in Fibre Channel storage configuration and administration:
•
•
•Compaq StorageWorks Fibre Channel Storage Switch User’s Guide
•Compaq StorageWorks SAN Switch 8 Installation and Hardware Guide
•Compaq StorageWorks SAN Switch 16 Installation and Hardware Guide
•Compaq StorageWorks Fibre Channel SAN Switch
•Compaq StorageWorks HSG80 Array Controller ACS Version 8.5 Configuration Guide