Compaq AA-RHGWC-TE manual Cabling the TL881 or TL891 DLT MiniLibrary

status until you exit the Menu Mode and the Ready light comes on once again.

2.Depress the down arrow button until the Configure Menu item is selected, then press the Enter button to display the Configure submenu.

____________________ Note _____________________

The control panel up and down arrows have an auto-repeat feature. When you press either button for more than one-half second, the control panel behaves as if you were pressing the button about four times per second. The effect stops when you release the button.

3.Press the down arrow button until the Set SCSI item is selected and press the Enter button.

4.Select the tape drive (DLT0 Bus ID: or DLT1 Bus ID:) or library robotics (LIB Bus ID:) for which you wish to change the SCSI bus ID. The default SCSI IDs are as follows:

•Lib Bus ID: 0

•DLT0 Bus ID: 4

•DLT1 Bus ID: 5

Use the up or down arrow button to select the item for which you need to change the SCSI ID. Press the Enter button.

5.Use the up or down arrow button to scroll through the possible SCSI ID settings. Press the Enter button when the desired SCSI ID is displayed.

6.Repeat steps 4 and 5 to set other SCSI bus IDs as necessary.

7.Press the Escape button repeatedly until the default menu is displayed.

8.12.2.1.2Cabling the TL881 or TL891 DLT MiniLibrary

There are six 68-pin, high-density SCSI connectors on the back of the TL881 or TL891 DLT MiniLibrary standalone model or rackmount base unit. The two leftmost connectors are for the library robotics controller. The middle two are for tape drive 1. The two on the right are for tape drive 2 (if the second tape drive is installed).

Configuring a Shared SCSI Bus for Tape Drive Use 8–63