
10.Use the Tab/Esc button to select Yes. Press Enter to reboot the switch and execute the POST tests.
____________________ Note _____________________
After changing any configuration menu settings, you must reboot the switch for the change to take effect.
Refer to the switch documentation for information on other switch configuration settings.
6.5.1.2.3Setting the
For the
To set the Ethernet IP address and subnet mask for the
1.Connect the switch serial port to a terminal or PC COM port with a standard serial cable with a DB9 connector. Note that the serial port is only used for initial
2.If you are using a PC, start a remote communication program, for example, HyperTerminal.
3.Set the port settings to 9600 bits per second, 8 bits per character, and no parity.
4.Turn on power to the switch and log in:
•
•
5.Enter the ipAddrSet command, then enter the IP address, subnet mask, and gateway address (if necessary). For example:
admin> ipAddrSet
Ethernet IP Address [10.77.77.77]: 16.142.72.54
Ethernet Subnetmask [255.255.255.0]: Return
Fibre Channel IP Address [none]: Return
Fibre Channel Subnetmask [none]: Return
Gateway Address [none]: Return admin> logout