Table
Callout Number | Description |
6 |
|
|
|
7 |
|
aThe maximum length of the BN38C (or BN38D) cable on one SCSI bus segment must not exceed 25 meters.
bThe maximum length of the BN37A cable must not exceed 25 meters.
cThe maximum combined length of these cables must not exceed 25 meters.
8.12.2.2Preparing a TL881 or TL891 Rackmount MiniLibrary for Shared SCSI Bus Usage
A TL881 or TL891 MiniLibrary base unit may also be used in a rackmount configuration with an expansion unit, data unit(s), and other base units, to add tape drive and/or cartridge capacity to the configuration.
The expansion unit is installed above the TL881 or TL891 DLT MiniLibrary base or data units in a SW500, SW800, or RETMA cabinet.
For complete hardware installation instructions, see the TL881 MiniLibrary System User’s Guide or TL891 MiniLibrary System User’s Guide.
The topics in this section provide information on preparing the rackmount TL881 or TL891 DLT MiniLibrary for use on a shared SCSI bus.
It is assumed that the expansion unit, base modules, and
8.12.2.2.1 Cabling the Rackmount TL881 or TL891 DLT MiniLibrary
You must make the following connections to render the DLT MiniLibrary system operational:
•Expansion unit to the
_____________________ Note _____________________
This cable is not shown in Figure
•Robotics control cables from the expansion unit to each base unit or data unit: These cables have a
