Compaq AA-RHGWC-TE manual HSG80 rename !NEWCON49 peppga1

____________________ Note _____________________

You can change the connection name with the HSG80 CLI RENAME command. For example, assume that member system pepicelli has two KGPSA Fibre Channel host bus adapters, and that the worldwide name for KGPSA pga is 1000-0000-C920-DA01. Example 6–1 shows that the connections for pga are !NEWCON49, !NEWCON50, !NEWCON54, and !NEWCON56. You could change the name of !NEWCON49 to indicate that it is the first connection (of four) to pga on member system pepicelli as follows:

HSG80> rename !NEWCON49 pep_pga_1

13.For each connection to your cluster, verify that the operating system is TRU64_UNIX and the unit offset is 0. Search the show connection display for the worldwide name of each of the KGPSA adapters in your cluster member systems. If the operating system and offsets are incorrect, set them, then restart both controllers as follows:

HSG80> set !NEWCON49 unit_offset = 0

HSG80> set !NEWCON49 operating_system = TRU64_UNIX HSG80> restart other

HSG80> restart this

.

.

.

HSG80> show connection

1

2

3

3

4

1

2

3

4

Set the relative offset for LUN numbering to 0. You can set the unit_offset to nonzero values, but use caution. Make sure you understand the impact.

Specify that the host environment connected to the Fibre Channel port is TRU64_UNIX. You must change each connection to TRU64_UNIX. This is very important. Failure to set this to TRU64_UNIX will prevent your system from booting correctly, recovering from run-time errors, or from booting at all. The default operating system is Windows NT, and NT uses a different SCSI dialect to talk to the HSG80 controller.

Restart both controllers to cause all changes to take effect.

Enter the show connection command once more and verify that all connections have the offsets set to 0 and the operating system is set to TRU64_UNIX.

6–32Using Fibre Channel Storage