Compaq AA-RHGWC-TE manual Example 6-6 Sample Fibre Channel Device Names, P00 show dev

Example 6–6: Sample Fibre Channel Device Names

P00>>> show dev
dga131.1001.0.1.0	$1$DGA131	HSG80	V8.5F
dga131.1002.0.1.0	$1$DGA131	HSG80	V8.5F
dga131.1003.0.1.0	$1$DGA131	HSG80	V8.5F
dga131.1004.0.1.0	$1$DGA131	HSG80	V8.5F
dga133.1001.0.1.0	$1$DGA133	HSG80	V8.5F
dga133.1002.0.1.0	$1$DGA133	HSG80	V8.5F
dga133.1003.0.1.0	$1$DGA133	HSG80	V8.5F
dga133.1004.0.1.0	$1$DGA133	HSG80	V8.5F
dgb131.1001.0.2.0	$1$DGA131	HSG80	V8.5F
dgb131.1002.0.2.0	$1$DGA131	HSG80	V8.5F
dgb131.1003.0.2.0	$1$DGA131	HSG80	V8.5F
dgb131.1004.0.2.0	$1$DGA131	HSG80	V8.5F
dgb133.1001.0.2.0	$1$DGA133	HSG80	V8.5F
dgb133.1002.0.2.0	$1$DGA133	HSG80	V8.5F
dgb133.1003.0.2.0	$1$DGA133	HSG80	V8.5F
dgb133.1004.0.2.0	$1$DGA133	HSG80	V8.5F
dka0.0.0.1.1	DKA0	COMPAQ BB00911CA0	3B05
dqa0.0.0.15.0	DQA0	COMPAQ CDR-8435	0013
dva0.0.0.1000.0	DVA0
ewa0.0.0.5.1	EWA0	08-00-2B-C4-61-11
pga0.0.0.1.0	PGA0	WWN 1000-0000-c920-eda0
pgb0.0.0.2.0	PGB0	WWN 1000-0000-c920-da01
pka0.7.0.1.1	PKA0	SCSI Bus ID 7	5.57

______________________ Note _______________________

The only Fibre Channel devices displayed by the console show dev command are those devices that have been assigned to a wwidn environment variable.

Before you start the Tru64 UNIX installation, you must set the bootdef_dev console environment variable.

6.6.1.5Set the bootdef_dev Console Environment Variable for Tru64 UNIX Installation

When booting from Fibre Channel devices, you must set the bootdef_dev console environment variable to ensure that the installation procedure is able to boot the system after building the new kernel.

______________________ Note _______________________

The bootdef_dev environment variable values must point to the same HSG80.

Using Fibre Channel Storage 6–49