______________________ Note _______________________
The tape drive SCSI connectors are labeled DLT1 (tape drive 1) and DLT2 (tape drive 2). The control panel designation for the drives is DLT0 (tape drive 1) and DLT1 (tape drive 2).
The default for the TL881 or TL891 DLT MiniLibrary is to place the robotics controller and tape drive 1 on the same SCSI bus (Figure
______________________ Notes ______________________
The internal cabling of the TL881 and TL891 is too long to allow external termination with a trilink/terminator combination. Therefore, the TL881 or TL891 must be the last device on the shared SCSI bus. They may not be removed from the shared SCSI bus without stopping all ASE services that generate activity on the bus.
To achieve system performance capabilities, we recommend placing no more than two tape drives on a SCSI bus.
We recommend that tape devices be placed on separate shared SCSI buses, and that there be no storage devices on the SCSI bus.
The cabling depends on whether or not there are one or two drives, and for the
______________________ Note _______________________
It is assumed that the library robotics is on the same SCSI bus as tape drive 1.
To connect the library robotics and one drive to a single shared SCSI bus, follow these steps:
1.Connect a
2.Install a
